2100t gyro setup

If it is opposite, we will need to reverse the gyro sensing. Enter gyro setup just like before, press and hold MENU button for a few seconds, until it enters setup mode. Use rudder stick to move the red LED to the 'other' position.

Gyro sensing direction is changed. Exit gyro setup mode. Your throttle curve is expected to be capable of maintaining reasonable headspeed for good hovering. Do a test hover and watch out for the tail, it is very likely to drift to either direction. Repeat this process as many times as required to get a close to perfect mechanical neutral so you can hover without the tail drifting. The better you can achieve this at this stage, the better your tail will work. This allows you to maximise performance out of your available tail travel.

Doesn't have to leave an 'empty' travel which other gyros can't use. Enter gyro setup mode. Now move the rudder stick gradually to the left, Watch the tail slider. Once the tail slider touches the end, the rudder stick may not be at it's end yet.

This is OK, stop moving the rudder stick and hold it at that position. Now press the MENU button once. You will notice one red LED will light up on one end. This means that the gyro has already registered that position as it's operating limit. You may see the LED is on the other end for your gyro but it's ok. We're not done yet! Now, move the rudder stick to the right, same thing, watch the tail slider. You will notice the red LED will light up on the opposite end. This means that the gyro has already registered that position as it's 'other' operating limit.

Now, try moving the rudder sticks all the way to it's ends, you will see the servo will stop at the registered spot and not push further. Again I will just mention again. The gyro has now 'memorised' the two ends' independent travel limits. No no no Ok, up to this stage the gyro is more or less set.

Page 11 Now, move the rudder stick to the right, same thing, watch the tail slider. Once the tail slider touches the end, the rudder stick may not be at it's end yet.

This is Page 12 OK, stop moving the rudder stick and hold it at that position. Now press the MENU button once. You will notice the red LED will light up on the opposite end. This means that the gyro has already registered that position as it's 'other' operating limit. Print page 1 Print document 22 pages. Rename the bookmark.

Delete bookmark? Cancel Delete. Delete from my manuals? Sign In OR. Don't have an account? Sign up! I wanted to build a. Thank you. Best Regards Patrick R. Speed: 0. The latest batch has the newest improvements done even to the precision of the servo internal programs! The freshest newest batch from Logictech direct! Originally posted by Razmo View Post.

Originally posted by ammo View Post. The LTGT remains the same, there could be minor tweaks but i cannot say for sure. However they have improved both components even the motor and internal programmings for the LTSG servo. After so many years, I am still a beginner. Zenm Tech Pte Ltd All rights reserved. Yes No.