To set the temperature, turn the thermostat control knob indicator mark to the required temperature. The heat is diffused by radiation. Recommended for: Intense grilling action for cooking with the broiler; The heat is diffused by forced convection with the most part being produced by the upper element. Set the temperature and the cooking program see the relevant sections.
To cook food automatically in the oven, it is necessary to: Once the oven is programmed it will 1. Set the length of the cooking time switch on automatically at the right time 2.
Failure to observe this rule will invalidate the warranty. Installation requires a compartment as illustrated in figures 5. On the lower side, the oven must lay on supports standing the oven weight. Using 4 screws not supplied the oven can be secured to the oven housing. Page 20 50 mm 30 mm Fig. The walls surrounding the oven must be made of heat-resistant material. Taking care NOT to lift the oven by the door handle.
The lower trim is designed to allow for good air circulation and the correct opening of the oven door. To ensure the trim is not damaged due to the appliance being placed on the floor, the appliance should be suitably supported as in above illustrations. If your appliance proves to be defective as a result of faulty materials or workmanship during the guarantee COMET will repair or replace it free of charge. Print page 1 Print document 25 pages.
Rename the bookmark. Delete bookmark? Cancel Delete. The heat is diffused by radiation. Use with the oven door closed and the To set the temperature, turn the thermostat thermostat knob must be regulated Heating and cooking in the fan oven are obtained in the following ways: The two elements which make this pro- cess take place are: a. Set the temperature and the cooking program see the relevant sections. To cook food automatically in the oven, it is necessary to: Once the oven is programmed it will 1.
Set the length of the cooking time switch on automatically at the right time 2. Always dry thoroughly. The shelf must be fitted so that the safety catch, which stops it sliding out, faces the inside of the oven.
The appliance must be installed in compliance with regulations in force. You need the following housing area to fit your oven correctly. The double oven is designed to fit into a cabinet of mm width. The double oven can be built in the kitchen units, but you must ensure that it is properly ventilated.
The lower trim is designed to allow for good air circulation and the correct opening of the oven door. To ensure the trim is not damaged due to the appliance being placed on the floor, the appli- ance should be suitably supported as in above illustrations. If your appliance proves to be defective as a result of faulty materials or workmanship during the guarantee COMET will repair or replace it free of charge.
Print page 1 Print document 25 pages. Rename the bookmark. Delete bookmark? Cancel Delete. Delete from my manuals? Sign In OR.
0コメント